Assembling The Vacuum Cleaner - Team kalorik TKG VC 1014 Manual De Instrucciones

Fax +32 2 359 95 50

If you use the appliance with a full dust container or saturated filters the appliance might

get damaged. Make sure to check the good quality and placement of the dust container
and/or filters.
If your appliance no longer vacuums correctly or if the dust container is full, clean the filter

and empty the dust container in order to prevent the appliance from overheating.
Your appliance must never be switched on through an external timer or any kind of

separate remote control system.
Competent qualified electrician: after sales department of the producer or importer or any
(*)
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this electrician.
Using the appliance when not all the filters are installed properly and in good shape might
damage the appliance. No guarantee claims will be accepted for damages due to that
reason.

ASSEMBLING THE VACUUM CLEANER

 Always remove the plug from the power socket before fitting or removing accessories!
 Insert the hose connector into hose connection inlet until it locks. To remove the hose,
press the sides of the hose connector and pull at the hose.
 When removing hose assembly, pull out hose connection wand with pushing down two
connection buttons.
 Fit the tube to the handle .
 Fit the tube to the floor brush .
 You can adjust the length of tube.
 Removing tube and accessories: to remove the accessories, pull firmly apart.
 The floor brush is ideal for the daily cleaning of carpets and hard floors.
Setting with the bristles inside for cleaning carpets.
Setting with the bristles outside for cleaning hard floors.
 The appliance is delivered with the following accessories:
OPERATIONS
 Pull out a sufficient length of power cord and insert the plug into the power socket. A
yellow mark on the power cable shows the ideal cable length. Do not extend the cable
beyond the red mark. Switch on the appliance by pressing the ON/OFF switch with your
foot.
 It is advisable to set the electronic power regulator to MIN before switching on the
appliance. By turning the regulator button, the suction power can be adjusted. You can
also adjust the suction power by using the wind-force adjuster on the handle. Use a low
suction power for furniture and other delicate surfaces and use high suction power for
fitted carpet and other floors.
AFTER USE
 Stop the vacuum cleaner by pressing the ON/OFF switch.
 Unplug the appliance from the power supply.
 Simply press the cable rewind button to activate the cable rewind mechanism.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
a crevice tool: for radiators, crevices, corners, baseboards

and between cushions.
an upholstery brush: for curtains, cushions, edges, doors,

mattresses etc.
9
Assembly page 9/41
special instruction from
TKG VC 1014 - 141230
Team