Initial Operation; Preparation Of Coffee - Team kalorik TKG CM 1008 Manual De Instrucciones

Ocultar thumbs Ver también para TKG CM 1008:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
Fax +32 2 359 95 50

INITIAL OPERATION

When you use your appliance for the first time, pour fresh water into the water tank (without
coffee) and switch on the appliance.
Once all the water has passed through, switch the appliance off and let it cool down. When it
is cold enough repeat the process with fresh water. Repeat this process 3 times.

PREPARATION OF COFFEE

Open the lid of the water tank.
Using the glass carafe, pour the desired amount of water into the water tank. Make sure
not to overfill by respecting the maximum level indicated on the water tank.
Place the filter holder into the coffee maker. Put a filter in the filter holder and, using the
provided scoop, add the desired quantity of ground coffee in the filter. Put back the filter
holder, making sure it is placed correctly.
Never forget to close the lid of the water tank and to place the glass carafe on the
warming plate before switching on your coffee maker.
Press the "power" button to switch on the coffee maker. The pilot light of the switch will be
illuminated, indicating that your appliance is working. A device allows you to keep coffee
warm for as long as the coffee maker is working and the jug is standing on the appliance.
Caution: the coffee maker will not turn off as long as you don't switch it off manually. We
advise you not to let the appliance switched on for more than 2 hours and make sure that
you never let an empty jug on the appliance.
When you remove the jug from the appliance, a non-drip valve will automatically operate
to stop any drops of coffee dripping onto the hotplate. Replacement of the carafe
automatically opens the non-drip valve and allows remaining coffee to filter through into
the jug.
Wait until the brewing process is finished and the filter has run empty before removing the
jug.
DECALCIFICATION AND CLEANING
Before cleaning, turn off the appliance, unplug it and let it cool down.
The filter, filter holder, carafe and carafe lid can be cleaned in a solution of warm water
and mild liquid soap.
The coffee maker can be cleaned using a damp cloth. Never immerse the body of your
coffee maker in water or any other liquid. Never use abrasive cleaning products or
solvents.
Decalcifying the coffee maker prolongs its life span. For decalcification only use products
especially made for decalcification of coffee makers.
Never use a dishwasher to clean the jug. Just clean it in soapsuds.
If the water in your region is hard, descale your coffee maker every 7 to 10 uses as follows:
Pour 3 cups of clean vinegar into the water tank and fill to the maximum level with water.
Place the carafe on the warming plate.
Plug in the coffee maker and press the "power " button.
When the water tank has emptied, switch off the coffee maker and empty the carafe.
Rinse the coffee maker two or three times by repeating the above process using cold
water only.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
6
Assembly page 6/32
TKG CM 1008 - 110201

Publicidad

Tabla de contenido
loading

Tabla de contenido