Cleaning And Maintenance; Environmental Protection - Concept CW1010 Manual De Instrucciones

EN
CHARGING
Before first use, charge the product for 4 hours.
The window vacuum needs to be charged for 4 hours for 30 minutes of continuous use.
How to charge:
1. Connect the lead from the charger to the charging port (11) on the window vac.
2. Plug the charger into the mains. During charging the indicator (10) will light red. When the window vac is fully
charged, the indicator will light green.
3. Remove the charger from the mains and the connector from the window vac.
Note: If the indicator is flashing, the window vac is not charging, press the power button (8) to reset the window vac.
ASSEMBLY
1. Put the squeegee vacuum head (1) on the main body. An audible click will be heard, when it is in place.
2. Use the velcro to attach the microfibre cloth (7) on the squeegee vacuum head.
HOW TO USE THE APPLIANCE
1. Wipe the front edge of the squeegee (1) to remove any impurities.
2. Remove the clean water tank cap (3) and fill the tank with water using the water jug. Make sure not to overfill. You
can add a small amount of window cleaning solution.
3. Pull trigger (9) to spray the solution on a window and wipe any excess dirt with the cloth.
4. Turn the window vac on by pressing the power button (8).
5. Move the window vac vertically from the top to the bottom of the window, until the window is clean.
6. Hold the window vac at the bottom of the window to suck any excess dirty water.
7. Turn the window vac off when the dirty water tank (12) is full.
8. Open the dirty water tank cap (6) and pour the content away.
Note: Always unplug the window vac from the charger before assembly, cleaning or maintenance.
TROUBLESHOOTING
Questions
It does not spray Fill the water tank with water.
Spray nozzle is blocked. Fill the tank with warm water and gently pull the
trigger to unblock the nozzle. If this fails, contact the customer service.
Water is leaking from the tank The water tank is overfilled or the dirty water tank is full. Check the rubber
sealing of the filter unit, if it is damaged, contact the dealer to provide
a new one.
It does not suck The vacuum is not charged sufficiently.
36
Answers
CW1010

CLEANING AND MAINTENANCE

• Do not immerse the main body in water.
• Always unplug the window vac from the charger before cleaning or maintenance.
• Wash the microfibre cloth in warm soapy water and let it dry properly.
• To clean the exterior of the window vac, wipe it with a soft damp cloth and then let it dry properly.
• Clean the squeegee vacuum head and spray head in warm soapy water and let it dry.
SERVICE CENTRE
Extensive maintenance or repair, which requires access to internal parts of the product, has to be performed by
a qualified service centre.

ENVIRONMENTAL PROTECTION

• Recycle packaging materials and old appliances rather than throwing them away.
• The appliance box may be disposed of at a sorted waste collection point.
• Deliver polyethylene (PE) plastic bags to a waste collection facility for recycling.
Recycling the product at the end of its service life
This appliance is labelled in accordance with European Directive 2012/19/EU concerning used
electrical and electronic appliances (waste electrical and electronic equipment - WEEE). The symbol
on the product or on its packaging indicates that this product may not be treated as household
waste. Instead it should be taken to the appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent
potential negative consequences for the environment and human health, which could otherwise
be caused by inappropriate waste handling of this product. The disposal of such material has to be
done according to the recycling regulations. For more detailed information about recycling of this
product, please contact your local council, your household waste disposal service or the shop where
you purchased the appliance.
Disposal of accumulators and battery cells
If an appliance contains an accumulator or a battery cell, these components contain substances that may damage the
environment when decomposing. Prior to the appliance disposal or the accumulator or battery cell replacement, it is
necessary to remove the original component and take it to a suitable designated collection yard.
WARNING!
An accumulator or battery cell:
• Never throw into a fire!
• Never disassemble it!
• Never short-circuit its terminals!
Should an accumulator or battery cell leakage occur, the leaked solution is of an alkaline character. If your skin gets
stained, rinse it immediately with soap and water and seek medical treatment.
This product meets all the basic EU regulation requirements that relate to it.
Changes to the text, design and technical specifications may occur without prior notice and we reserve the right to
make these changes.
CW1010
EN
37