Cleaning Modes; Cleaning And Maintenance - Concept VR2000 Manual De Instrucciones

EN
CLEANING PLANNING
To set the cleaning mode, press the button
the time. To set the values, use the ˄ ˅ buttons. Confirm the time by pressing the OK button. Then the right side
of the display starts to flash to set the minutes. Follow the same steps as the hour setting.
The vacuum robot will vacuum each day at the time you have set.
To cancel the scheduled cleaning, set the scheduled cleaning time to 00:00.
MOPPING THE FLOOR
If you have a water tank installed, the Open the sealing cap and fill
vacuum robot automatically enters with water, close the sealing
the mopping the floor mode. Water cap after filling.
spontaneously passes through the
mopping cloth. The water tank is
washable. Always pour the water only
after removing the water tank from the
body of the vacuum robot.
WATER TANK
1. Rubber closure
2. Water tank
3. Dust bin
BOTTTOM SIDE OF THE WATER TANK
1. Mopping cloth
2. Velcro fastener
3. Water inlets
88
on the remote control. At first, two digits begin to flash to set
1
2
3
3

CLEANING MODES

Automatic mode
The Concept VR2000 uses advanced navigation to calculate the best way to achieve effective cleaning. To activate
this mode, press the
Edge cleaning path mode
To activate this mode, press the
walls where the dust is most often. To cancel this mode, press the button of any other mode.
Circular mode
Place the vacuum robot in places where you want to perform a targeted cleaning (approx. area of 1 m
activate this mode, press the
this mode, press the button of any other mode.
FULL GO mode
To activate this mode, press the
clean as soon as it is fully charged at the charging base.
Automatic

CLEANING AND MAINTENANCE

1
Battery
• Allow the battery to charge for more than 6 hours before first use.
• In case of low battery detection during cleaning, the vacuum robot automatically searches for the charging
base and starts to charge.
• If the appliance is being transported or it is not used for a long time, switch it OFF with the main switch.
2
• If you do not use the robotic vacuum robot for more than 3 months, allow it to charge for 12 hours, then turn
it OFF with the main switch and place it in a dry and cool place.
• It is highly recommended to use the charging base for charging.
• Remove the batteries from the remote control if you do not use the vacuum robot for a longer time.
• The vacuum robot is equipped with a special shield that stops supplying power and prevents overcharging.
This ensures its long service life and at the same time the vacuum robot is ready to start cleaning again.
VR2000 VR2000
button on the vacuum robot body or on the remote control.
button on the remote control. The vacuum robot will vacuum along the
button on the vacuum robot body or on
button on the remote control. The vacuum robot automatically starts to
Edge cleaning path Circular
EN
2 ). To
the remote control. To cancel
Zig-zag
89