Maintenance And Storage - Sthor 82967 Manual Del Usuario

Using the appliance
After assembling the dust container and the selected accessories,
make sure that the power switch is in the off position - OFF (VII),
then plug the power cord plug into the electrical system of the vehi-
cle. Turn the vacuum cleaner on by moving the power switch to the
on position - ON (VII), then start cleaning.
The vacuum cleaner is turned off when the power switch is set to
the off position - OFF.
Control the amount of dust in the container during operation. Place
the container in a vertical position with the lid pointing downwards.
The dust level should not be higher than the fl ange of the external
fi lter, above which the perforated part of the fi lter begins. Empty the
container, if necessary.
If the LED does not light up when the plug is connected, and the
vacuum cleaner does not work, the fuse in the plug may burn out.
If this is the case, replace it with a new one. To do this, unscrew the
mounting ring, remove the plug contact and the fuse. Assemble in
reverse order (VIII).
Caution! If suspicious vibrations, a drop in thrust force or noisier mo-
tor operation are observed during operation, this may mean that the
tank is full or that the fl exible hose or suction attachment is clogged.
In this case, turn off the vacuum cleaner immediately with the switch
and unplug the power cord from the mains socket. Then empty the
tank and check the permeability of the fl exible hose and attachment.
Unblock them, if necessary. If it is not possible to unblock the fl exible
hose or the suction attachment, replace them with new ones before
continuing to work.

MAINTENANCE AND STORAGE

CAUTION! Never immerse the vacuum cleaner in water or other
liquids. Doing so may result in electric shock.
After cleaning, turn off the vacuum cleaner with the switch, discon-
nect the power cord plug from the socket, disconnect the accesso-
ries, and proceed with maintenance.
Disconnect the dust container from the vacuum cleaner. Open the
lower lid of the container and discharge the impurities collected in
the container. Open the top lid, remove both fi lters. Clean the con-
tainer with a damp, soft cloth, then dry with a dry cloth or allow it
to dry.
Warning! It is forbidden to use the vacuum cleaner with a wet or
damp fi lter. This can result in electrocution.
The plastic and steel fi lter can be rinsed under running, lukewarm
water. Next dry with a dry cloth and allow to dry completely. Wait
at least 24 hours after placing the fi lter in a well-ventilated place at
room temperature.
Do not wash fi lters in mechanical dishwashers and do not dry them
with a stream of hot air. This can cause deformation of the plastic
O R I G I N A L
10
GB
material used for the construction of the fi lter. Avoid exposing the
fi lters to direct sunlight.
No other part of the vacuum cleaner must be exposed to water. Gen-
tly tap the internal fi lter to shake off larger impurities. In the case of
excessive contamination, replace the fi lter with a new one.
Clean the remaining parts of the vacuum cleaner with a cloth slightly
soaked in water, then dry or allow to dry.
Store the vacuum cleaner in the supplied cover. The storage area
should protect the appliance against sunlight and moisture as well
as ensure proper ventilation. The storage area temperature should
be in the range from 0 to +40° C.
I N S T R U C T I O N S