Fermax MEET WIT 10 Guía Rápida página 2

QUICK GUIDE
Cod. 970090 V10_20
MEO/WIT MEET MONITORS INSTALLATION
CONNECTIONS
Further information at meet.fermax.com
BASIC DIAGRAMS
LAN #1 SWITCH IN BUILDING. PoE
LAN #1 SWITCH IN BUILDING. NO PoE
LAN #1 SWITCH IN BUILDING. PoE
LAN #1
SWITCH IN BUILDING. PoE
LAN #2 SWITCH IN APARTMENT. NO PoE
LAN #1: Local LAN connection (WIT 10" only).
LAN #2: Building LAN connection.
+12V, -: 12 Vdc power supply for the cases where no
LAN PoE is available.
RS485+, RS485-, 12V: RS485 connection for Ref.
1616 Module.
S: 12Vdc 100 mA alarm output.
(-):
Negative common (alarms input and output).
Z1-Z8: Input alarms sensors (Z1-Z8).
NOTE: Z8 is reserved for tamper sensor.
PoE Supply
Aply to:
WIT 7" & 10" MONITORS
12 Vdc supply
Aply to:
MIO 7" & 10" MONITORS
WIT 7" & 10" MONITORS
Suppy by means of a splitter
Aply to:
MIO 7" y 10" MONITORS
LAN#2 CONNECTION
Aply to:
WIT 10" MONITOR
TERMINAL BASIC PROGRAMMING
Enter the basic configuration information:
- Block number
- Apartment number
- Monitor number (default "0")
- IP address
- Subnet mask
- Gateway
- DNS
Enter installer password
Default password: 6666.
PC BASIC PROGRAMMING
Use a PC with web browser (preferably Chrome)
Default IP: 10.1.1.1
NOTE: The PC must have an IP of the same range as the
IP of the panel
EXAMPLE: In the case that the IP of the panel is 10.1.1.1,
the IP of the PC must be of type 10.X.X.X with a subnet
mask 255.0.0.0
Enter the network basic information:
- IP address
- Mask
- Gateway
- DNS
To login, identify yourself with
the username and password.
Default value:
• Username: admin
• Password: 6666
Enter the installation basic information:
- Block number
- Apartment number
- Monitor number (default "0")