Wall Mounting - Italtecnica Nettuno 2.0 Manual De Instrucciones


INSTALLATION

DEVICE FIXTURE:
Nettuno is supplied with a special fixing bracket to enable mounting directly on a wall, or the option of fixture to a
horizontal pipe using the optional kit.
On both wall-mounted and pipe-mounted versions, ensure that fixture is secure and that the pipe or wall is
sufficiently strong to withstand the weight of the device.
Always install indoors, in an area protected against dust and water. Nettuno must be installed at a higher point than
the pump to avoid the risk of immersion in the event of flooding.
The device must never be installed in confined spaces that can reduce ventilation and therefore cooling of the
inverter.

WALL MOUNTING

Nettuno can be mounted on a wall or other flat surface by means of the bracket and screws supplied. For simple
installation of the product, proceed as described below.
1)Fix the bracket to the wall by means of the 4
screws supplied. Check to ensure correct
horizontal alignment.
3) Fit Nettuno onto the bracket, passing the
screw heads on the larger holes and then
slide downwards.
2) Pre-assemble the fixing screws on the
rear side of Nettuno, leaving a space of at
least 3mm under the screw heads.
4) Tighten the rear screws fully down on
Nettuno.
29