Electrical Connection - Italtecnica Nettuno 2.0 Manual De Instrucciones

 ELECTRICAL CONNECTION:
CAUTION:
- all wiring up must be carried out by specially trained personnel
- an incorrect motor connection could result in damage to the device or the pump motor.
- failure to comply with what is stated in this paragraph may cause serious damage to things and/or serious
injuries to people, and the manufacturer declines all responsibility.
- if the power supply cable or the cable between Nettuno and the electric pump is damaged, only the
manufacturer of the device, its appointee or equally qualified personnel can replace it; this is to prevent risks
.
to things and people
Fit the electric wires into the relative wire clamps, making sure the correct assembly order is maintained for all the
components. Secure the threaded nuts tightly enough to prevent the wires being pulled or turned from the outside.
Use cable clamps in metal for connection of the power line and those in plastic for connection of any I/O (auxiliary
inputs and outputs).
POWER
INPUT
The metal plates located in the vicinity of the cable clamps can be used to connect the shielding of the cables and
thus ensure correct continuity of the shielding itself with the heat sink.
AUXILIARY
INPUTS/OUTPUTS
SHIELDING
CONNECTION
32
MOTOR
OUTPUT