Dimensions (Mm) - Cointra Cosmos Instrucciones De Instalación

The thermal emitter must be fixed to the wall using the spacers, brackets, screws and wall plugs
supplied with the device, according to the instructions on the template printed on the box.
If you do not have this template, you can follow the instructions:
1. Make sure you keep your eye on where the lower hole on the wall is.
Model
COSMOS 500
COSMOS 750
COSMOS 1000
COSMOS 1200
COSMOS 1500
(*) The first number corresponds to the number of plastic brackets on which the emitter hangs and the second
number corresponds to the number of metal locking brackets which fixes the emitter to the wall.
2. Screw in each of the brackets using the lower hole and mark the upper holes of each wall
bracket.
3. Drill all the marked locations in the wall and insert
the wall-plugs, screw the brackets to the wall and
hang the emitter.
4. Metal locking bracket: Tighten the screw at the top of the bracket until the emitter is locked
in position.
74
EN
Dimensions
No. of
(mm)
brackets (*)
A B
160 80
240 160
320 160
400 240
560 320
2+1
A73023080