Easy Mode - Cointra Cosmos Instrucciones De Instalación

Ocultar thumbs Ver también para Cosmos:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

During the configuration of the internal parameters, if no key is touched for 30 seconds, the emitter
will return to the previous mode of operation.

5.11 EASY MODE

Once the emitter is set into the Easy Mode, it will only allow the user to increase and decrease the
temperature setting.
There is no access to the clock, mode or configuration changes and no keyboard lock, just the
heating icon showing if the emitter is currently heating, the current room temperature and the Wifi
symbol showing if the emitter has a Wifi network linked or not.
Only the Standby, p and q keys are operational.
The configuration values are set as shown below and cannot be modified in Easy Mode:
1 - Brightness level at rest: Level set in 1P (Normal Mode)
2 - Maximum brightness Time: Time set in 1P (Normal Mode)
3 - Open Windows: OFF
To modify the brightness values used by the emitter in Easy Mode (2P), they must be previously
set in Normal Mode (1P). The Open Windows function will always be disabled in Easy Mode, re-
gardless of its setting in Normal Mode.
The emitter temperature set point is adjustable with the p and q keys between 12 °C and 30 °C,
in steps of 0.5 °C.
If the emitter is set into the Easy Mode without having been linked to a Wifi network before, it will
not be able to be linked until it is set into the Normal Mode again and follows the required steps.
Once the COSMOS emitter has been linked to a Wifi network, it can be set into the Easy Mode and
then be remotely controlled using the COINTRA ELECTRIC Application, but just with the simple
available control options explained above.
Through the Application, the COSMOS emitter can be set in Normal Mode or Easy Mode at any
time.
Note:
When remotely controlling an emitter in Easy Mode by the COINTRA ELECTRIC Application, its
brightness level at rest and its maximum brightness time can be directly configured, without previ-
ously setting it in Normal Mode.
The new configured values will be used if returning the emitter to Normal Mode.
97
A73023080
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido