Reset - Cointra Cosmos Instrucciones De Instalación

When accessing the Rate menu with the OK key, the following screens appear:
There are 4 options to configure; When q or p is touched, the option changes position, and
screen, depending on whether you switch between Standard Rate and Reduced Rate:
Whenever you want to change one of the 4 options, once in the required option, touch OK.
•
The symbols q and p will appear on the sides, with the value inside to be modified flashing.
• When proceeding to modify the relevant value, it can be increased or decreased with the p or
q keys. To do it quickly, press and hold down the key.
In this Rate menu, if the Mode key is touched, the emitter will return to the Energy menu. If no key
is touched for 30 seconds, the emitter will return to the last operating mode.
Reduced Rate Configuration:
If you want to establish a Reduced Rate, you need to configure its period and its correct price.
Reduced Rate Period:
The Reduced Rate applies from Start Time to End Time. If within the 24-hour period, the Start
Time is "later" than the End Time, the entire period possible is applied until the End Time occurs,
even if it falls on the next day. For example, we could configure:
Start Time: 23:00
End Time: 06:00
In this example, the duration of the reduced rate would be 7 hours, leaving the standard rate ap-
plicable from 06:00 to 23:00.
To establish a single Standard Rate, you must simply have the Start Time and End Time exactly
the same time, either 00:00 (default option), or any other time.
Reduced Rate price with respect to Standard Rate price
The Standard Rate price can always be configured or modified. The price of the Reduced Rate
can never be greater than the price of the Standard Rate.

5.4.5.3 Reset

It is the last option in the Energy menu and there are 3 menu options, which can be selected with
the q and p keys:
Type of METER to Reset // OK // CANCEL
A73023080
89
EN