In order to enable the heating again, the user must touch the Mode key. The emitter will then
return to the previous mode of operation.
Note: In installations where this function is activated very frequently, it may be appropriate to keep
it disabled.
* This function is considered by Directive 2009/125/EC regulations and will give the unit
more efficiency during operation.
5.8 ADAPTIVE START CONTROL FUNCTION
When the Adaptive start control function is enabled in the Configuration menu, the emitter
automatically starts heating prior to the programmed time (a maximum of 2 hours before), to
ensure that the next "on" set point is reached efficiently.
The emitter analyses the next two hours, and if there is a set point higher than
the current room temperature within that period, and knowing the heating speed
of the unit, the software calculates when it needs to start heating. This calculation
is made every 5 minutes.
This function only runs when the emitter is in Program mode. When Adaptive
start is running, a flashing clock icon is displayed next to the thermometer icon.
This function will only operate on temperature rise, e.g., from anti-frost to eco/
comfort, or from eco to comfort.
When Adaptive start is running the emitter progressively increases the set point temperature until
the next programmed set point is reached.
* This function is considered by Directive 2009/125/EC regulations and will give the unit
more efficiency during operation.
5.9 KEYBOARD LOCK
The user can lock the emitter keyboard by touching and holding
the p and q keys for 2 seconds; the keyboard can be unlocked
in the same way.
When the keyboard is locked or unlocked, the screens on the
right are displayed.
When the emitter is locked, the padlock icon will appear in the upper area of the screen. It is
possible to lock the emitter in all modes, even Standby mode.
Note: these keyboard lock and unlock actions can also be performed from the COINTRA ELEC-
TRIC Application if the emitter is linked to a Wifi network.
95
A73023080
EN