Loading A Dvd Or Cd; Manually Ejecting A Dvd Or Cd; Using Dvd - IBM OPTIONS 46P6374 Guia Del Usuario

Loading a DVD or CD

1. Press the Eject button. The tray slides out of the drive.
2. Place the disc in the tray with the label facing up.
3. Close the tray by gently pushing the tray in until it latches.
Attention: Do not use force or insert foreign objects to open the tray. If your tray does
not open when you press the Eject button, see "Manually ejecting a DVD or CD" for
more information.

Manually ejecting a DVD or CD

If you press the Eject button and the tray does not slide out, turn off the
computer and straighten a large paper clip to form a tool, as shown in the
illustration. The straightened end must extend at least 45 mm (1.8 in.). Insert
the extended end into the manual-eject hole on the front of the drive. Push the
paper clip until the tray opens. Gently pull out the tray until you can remove
the disc.

Using DVD

To use DVD, you need to set up your computer as follows after installing the
CD-RW/DVD drive into the Ultrabay 2000 drive bay:
1. Enable the DMA setting (Windows 98, Windows 95, and Windows 2000
users only).
2. Install WinDVD (the DVD movie player program).
About the CD-RW/DVD Combination II Ultrabay 2000 Drive
1-5