IBM OPTIONS 00N8069 Manual De Instrucciones página 10

Installing the NVIDIA Graphics Adapter
To install the NVIDIA Graphics Adapter:
1. Turn off all attached devices; then turn off the computer. Unplug all cords
and power cables from the computer and all attached devices. Remove the
cover from your computer. For instructions on how to remove the cover
from your computer, refer to the documentation that comes with your
computer.
®
For IBM computers, refer to your user guide for instructions on opening
the computer cover, removing existing adapters, and installing adapters in
expansion slots.
2. Remove any previously installed graphics adapters. If you have no other
graphics adapters but your computer system board has built-in VGA
graphics capability, make sure that the VGA graphics capability is disabled.
For information on disabling the VGA graphics capability on your
computer, see the documentation that comes with your computer.
3. Choose an AGP expansion slot.
Attention: Inserting a graphics adapter into the wrong type of slot might
damage your adapter, your computer, or both.
To identify the location of each type of expansion slot in your computer,
refer to the documentation that comes with your computer.
Attention: Do not insert the plastic tab next to the connector pins into the
expansion slot.
4. Remove the expansion-slot cover for the expansion slot that you intend to
use. Save the screw to use with the mounting bracket.
5. Position the graphics adapter over the expansion slot you have chosen.
Push the graphics adapter in firmly and evenly until it is fully seated in the
slot.
6. Using the screw from the expansion slot cover, secure the mounting bracket
of the graphics adapter to the computer frame.
7. Replace the cover on your computer.
8. If you have a digital or analog monitor with DVI connectors, plug your
monitor cable directly into the graphics adapter connector. Plug the other
end of the monitor cable into your monitor.
Refer to the documentation that comes with your monitor to make sure
that the monitor is properly set up.
9. Plug the cables for any other attached devices into your computer. Plug the
power cables for the computer, monitor, and other attached devices into a
power outlet; then turn on the computer and all attached devices.
1-2
NVIDIA Graphics Adapter: User's Guide