Installing The Thinkpad System Hard Disk Drive Into The Adapter - Lenovo ThinkPad 40Y8746 Guia Del Usuario

5. Insert the adapter into the drive media bay.
Note: For information on the drive media bay, refer to your system
documentation.
Installing the ThinkPad system hard disk drive into the
adapter
To install a ThinkPad system hard disk drive into the adapter, complete the
following procedure:
1. Lift the adapter retaining latch.
2. Replace the hard disk drive, if necessary. To replace the hard disk drive, do
the following:
a. Turn off your ThinkPad computer.
b. Disconnect the ac adapter and all cables from the computer.
c. Close the display and turn the computer over.
d. Remove the battery.
e. Remove the screw that secures the hard disk drive.
f. Remove the cover, then remove the hard disk drive by pulling on the
tab.
g. Detach the side rubbers from the hard disk drive.
h. Unpack the new drive.
1-3
Installation