Emporio Armani AR2434 Manual De Instrucciones página 18

CHRONOGRAPH
Time Setting
CHRONOGRAPH
1. Pull crown out to
position 3 (the
CHRONOGRAPH
watch stops).
MINUTE HAND
2. Turn crown to set the
desired time.
3. Return crown to
position 1.
NOTE: In order to set
CHRONOGRAPH
MINUTE HAND
the time to the exact
second, the crown
CHRONOGRAPH
must be pulled out
when the second hand
is in position "60." Once
the hour and minute
hands have been set,
the crown must be returned to position 1.
date Setting
1. Pull crown out to position 2 (the watch continues to run).
2. Turn crown until the correct date is shown in the date window.
3. Return crown to position 1.
NOTE: During the date changing phase between 9pm and 12pm, the
date must be set to the date of the following day.
Chronograph: basic
1. Start: press A.
2. Stop: press A.
3. Reset: press B (the three chronograph hands will be reset to their
zero positions).
Chronograph: Accumulated timing
1. Start: press A (start timing).
2. Stop: press A (e.g. 15 min 5 sec).
3. Restart: press A (timing is resumed).
4. Stop: press A (e.g. 13 min 5 sec) = 28 min 10 sec (the accumulated
measured time is shown).
34
SECOND HAND
CHRONOGRAPH
HOUR HAND
HOUR HAND
SECOND
HAND
5. Reset: press B (the three chronograph hands are returned to their
zero positions).
NOTE: The accumulation of the timing can be continued by pressing
SECOND
A
HAND
A (Restart / Stop, Restart / Stop, ...).
Chronograph: Intermediate or interval timing
1 2 3
1. Start: press A (start timing).
2. Display interval: press B (e.g. 10 minutes 10 seconds, timing
B
continues in the background).
3. Making up the measured time: press B (the 3 chronograph hands
are quickly advanced to the ongoing measured time).
A
NOTE: Further intervals or intermediates can be displayed by
pressing B (display interval / make up measured time, ...).
4. Stop: press A (final time is displayed).
5. Reset: press B (the 3 chronograph hands are returned to their
1 2 3
zero position).
B
Adjusting the chronograph hands to zero position
One or several chronograph hands are not in their correct zero
positions and have to be adjusted (e.g. following a battery change).
1. Pull the crown out to position 3 (all 3 chronograph hands are in their
correct or incorrect zero position).
2. Keep A and B depressed simultaneously for at least 2 seconds (the
center stop-second rotates by 360°, corrective mode is activated).
3. Press A to single step the center stop-second hand. Press and hold
A to advance the center stop-second hand quickly. Press B to adjust
the next hand.
4. Press A to single step the hour counter hand. Press and hold A
to advance the hour counter hand quickly. Press B to adjust the
next hand.
5. Press A to single step the minute counter hand. Press and hold A to
advance the minute counter hand quickly.
6. Return crown to position 1 (termination of the chronograph
hands adjustment).
35