Transportation And Storage; Maintenance And Cleaning; Locating Faulty Components; Service And Repair - RIDGID SeekTech SR-20 Instrucciones De Operación

seekTech sR-20
Tools For The Professional
TM
Menu Tree
Activated Frequencies
Sonde
Line Trace
Power (Passive Trace)
Radio
Units of Measure
Feet/Meters
Backlight Options
On/Off/Auto
LCD Contrast
Increase/Decrease
Display Elements Select
(Check On/Off )
Trace Mode
Watermark
Signal Focus Setting
No-Signal Indicator
Sound Signals
Center Signal Strength*
Signal Strength
Proximity Threshold*
Signal Angle Indicator
Distortion Line*
Tracing Line Distortion Response*
Sound Mute > 99'
Guidance Arrows*
*=Line Trace Display Only
Frequency Select (Check On/Off)
Sonde
16 Hz, 512 Hz, 640 Hz, 16 kHz, 33 kHz
Line Trace
128 Hz, 1 kHz, 8 kHz, 33 kHz
Power
50 Hz , 50 Hz
x1 x5
60 Hz , 60 Hz
x1 x5
100 Hz, 120 Hz, <4 kHz
RF
Low (4-15 kHz)
High (>15 kHz)
Information Menu
Restore Default Settings
(Check Yes/No)
Figure 37: Menu Tree

Sonde Mode
, 50 Hz ,
x9
, 60 Hz ,
x9
Ridge Tool Company
SR-20 Maintenance

Transportation and Storage

Before transporting, make sure that the unit is off to preserve
battery power.
When transporting, make sure that the unit is secure and does
not bounce around or get bumped by loose equipment.
The SR-20 should be stored in a cool dry place.
NOTE: If storing the SR-20 for an extended period, remove
the batteries completely.
If shipping the SR-20, remove the batteries entirely from
the unit.

Maintenance and Cleaning

1. Keep the SR-20 clean with a damp cloth and some
mild detergent. Do not immerse in water.
2. When cleaning, do not use scraping tools or abrasives
as they may permanently scratch the display. NEVER
USE SOLVENTS to clean any part of the system.
Substances like acetone and other harsh chemicals
can cause cracking of the Case.

Locating Faulty Components

For troubleshooting suggestions, please refer to the
troubleshooting guide.

Service and Repair

IMPORTANT! Instrument should be taken to a RIDGID
Independent Authorized Service Center or returned to the
factory. Remove batteries before shipping.
All repairs made by Ridge service facilities are warranted
against defects in material and workmanship.
If you have any questions regarding the service or repair of
this machine, contact your RIDGID distributor, local RIDGID
office or Ridge Tool Europe at info.europe@ridgid.com.