Publicidad
Important! The fitting must be installed, flushed
and tested after the valid norms!
Assembly
1.
Flush through the supply pipes.
2.
Place the mixer including the sealing
washer in position on the sink.
3.
Slip the plastic washer, the slide washer,
the metall washer and collar over the hoses
and threaded base and tighten the collar nut
by hand. If there is not enough space,
please use only the slide washer and the
metal washer without the plastic washer.
4.
Tighten screws.
5.
Connect the supply pipes to the isolation
valves; cold right - hot left.
The hot and cold supplies must be of equal
pressures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
Technical Data
Operating pressure:
Recommended operating pressure:
MPa
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Rate of flow:
assembly instructions
max.: 1 MPa
0,1 – 0,5
1,6 MPa
max. 80°C
65° C
11 l/min 0,3MPa
Hansgrohe single lever mixers can be used
together with hydraulically and thermically
controlled continuous flow heaters if the flow
pressure is at least 0,15 MPa.
To adjust the hot water limiter on single lever
mixers, please see page _1b.
No adjustment is necessary when using a
continuous flow water heater.
Spare parts see page 3 + 4
1
handle
1.1 screw cover
2
flange
3
nut
4
cartridge cpl.
5
aerator cpl.
6
fixing set
7
connection hose 900 mm 3/8"
8
connection hose 900 mm
9
connection hose 900 mm
10
shut off unit, Elastop
11
seal
12
sealing set
33891000
96338000
96391000
94194000
92730000
13913000
95049000
98696000
98758000
94082000
94849000
95008000
96529000
5
Publicidad
