Start And Operation - auna Billy Bob Manual Del Usuario

EN
12

START AND OPERATION

Firmly and securely insert the DC plug of the adaptor to the DC IN Jack on
the back of the unit. Plug the adaptor's AC plugs into a power outlet.
Phono Mode
1. Switch the function knob to PH mode. Turn on the power switch. The
indicator will become red color.
Note: During the phono mode, please make sure that the AUX IN jack
was not plugged in with the audio cable. If there is an audio cable
plugged in, the default mode is AUX IN.
2. Place a record on the turntable platter and select the desired speed
(33/45/78) according to the record.
Note: when playing a 45RPM record, use the included 45RPM adaptor.
3. Remove the stylus protector. Open the tone-arm clip to release the
tone-arm. Push the lift lever backward to raise the tone-arm and
gently move the tone-arm to the desired position over the record. The
turntable will begin to spin when the arm is moved toward the record.
Push the lift lever forward to lower the tone-arm slowly onto the desired
position on the record to begin playing the record.
Note: The record will begin to spin only when the tone-arm is moved
toward the record if the Auto Stop is turned on.
4. If the Auto Stop Control Switch is turned ON, the record will stop
automatically when finished. If Auto Stop Control Switch is turned OFF,
the record will NOT stop automatically when finished.
Note: AUTO STOP function applies to most 33RPM vinyl records.
However, for very few vinyl records, it will stop when it does not come to
the end, or it will not stop when it comes to the end when AUTO STOP
is ON.