Kit Assembly; Iso Din Radio Provision With Pocket; Iso Ddin Radio Provision; Final Assembly - Metra 99-5835G Instrucciones De Instalación

KIT ASSEMBLY

ISO DIN radio provision with pocket

1. Attach the pocket to the radio brackets
using the (4) supplied #8 x 3/8" Phillips
truss head screws. (Figure A)
2. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
3. Slide the radio into the completed
assembly and then secure it using the
screws supplied with the radio.
(Figure B)
Continue to Final Assembly

ISO DDIN radio provision

1. Attach the radio brackets to the radio
using screws supplied with the radio.
(Figure C)
Continue to Final Assembly
(Figure A)
(Figure B)
(Figure C)

FINAL ASSEMBLY

1. Cut the shaded portion from the
sub-dash of the vehicle to allow the
radio to fit. (Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or AXXESS. Test the radio for
proper operation.
Remove shaded area
(Figure A)
3. Secure the radio into the dash.
4. Snap the radio trim panel over the radio
and then reassemble the dash in reverse
order of disassembly.
REV. 7/27/21 INST99-5835G
3