Dash Disassembly; Kit Preparation - Metra 99-5835G Instrucciones De Instalación

DASH DISASSEMBLY

1. Unclip the dash panel above the radio.
(Figure A)
2. Remove (2) T-20 Torx screws securing the
factory radio/trim panel. (Figure B)
3. Unclip the factory radio/trim panel from
the dash, unplug and remove. (Figure B)
4. Remove (1) T-20 Torx screw per vent then
unclip and remove the vents from the
factory radio/trim panel. (Figure C)
5. Unclip and remove the hazard switch
assembly from the factory radio/trim
panel. (Figure D)
Continue to Kit Preparation
(Figure A)
2
(Figure B)
(Figure C)
(Figure D)

KIT PREPARATION

1. Secure the factory vents to the radio
trim panel using the (2) #8 x 3/8"
Phillips pan head screws provided.
(Figure A)
2. Snap the factory hazard button into the
radio trim panel. An airbag light blank
has been included for models without a
passenger airbag indicator. (Figure A)
(Figure A)
(Figure B)
3. Attach the (4) plastic panel clips
provided to the radio trim panel.
(Figure B)
4. Attach the (12) metal panel clips
provided to the dash panel. (Figure C)
Continue to Kit Assembly
(Figure C)
|
1-386-257-1187 MetraOnline.com