Sony SU-WL500 Manual De Instrucciones página 8

Step 5:
Installing the monitor
on the wall
WARNING
Be sure to complete the installation before
connecting the AC power cord to the wall outlet. If
you allow the AC power cord to be pinched under
or between pieces of equipment, this may result
in a short circuit or an electric shock.
Be careful not to stumble over the AC power cord
or the monitor, as you may hurt yourself.
1
Connect the AC power cord and
the connecting cable(s) supplied
with the monitor to the monitor.
Connect the AC power cord and the connecting
cable(s) to the connectors on the rear of the
monitor. For details on connecting the AC power
cord and the connecting cable(s), refer to the
instruction manual of the monitor.
Notes
• You cannot connect the cables to the monitor after
installing it on the Base Bracket.
• Subcontract the cable routing in the wall to a
licensed contractor.
8
(GB)
2
Install the monitor onto the Base
Bracket.
 Referring to the Screw and Hook locations
diagram/table on page 21, determine the
holes of the Base Bracket for latching the
upper hooks of the Mounting Hook.
 Hold the monitor securely with both hands,
and gently align it on the wall.
WARNING
• Be sure that two or more persons hold the monitor
when carrying it.
• When carrying the monitor, hold it in landscape
orientation, and take care not to drop it when
installing. Do not apply excessive force to the
monitor; otherwise, it may be deformed.
Mounting Hook
Base Bracket