Cooper Lighting PHL300 Manual De Instrucciones página 4

PHL300 325-1576.qxd 8/22/06 4:13 PM Page 4
How to use
The fixture is packed in the compact storage position. Remove the fixture from
the carton. Loosen knobs on the sides of the fixture and swing the fixture up so
that the wire lens guard is directly above the closed (curved) portion of the tubu-
lar steel stand. Retighten the knobs. (Reverse this procedure to fold down
the light fixture for convenient, compact storage.)
Plug the female end of your 3 wire grounded extension cord into the receptacle
located in the back of the light fixture and then plug the male end of your exten-
sion cord into any standard grounded 120 Volt wall receptacle. Push the red
on/off/dimmer switch on the light (located on the back of the fixture). The switch
has three positions: 150 watts, 300 watts, and off.
Aiming the light
Loosen the knobs located on the sides of the light housing. Using the top
carrying handle, tilt to desired position, then retighten knobs.
Warning: Deviation from the assembly instructions may result in
a risk of fire or electric shock.
SAVE THESE INSTRUCTIONS.
Two year limited warranty
Cooper Lighting ("the Company") warrants this product ("the product") against
defects in material or workmanship for a period of two years from date of
original purchase, and agrees to repair or, at the Company's option, replace a
defective product without charge for either replacement parts or labor during
such time. This does not include labor to remove or install fixtures.
This warranty is extended only to the original purchaser of the product.
A purchasers receipt or other proof of date of original purchase acceptable to
the Company is required before warranty performance shall be rendered.
This warranty only covers product failure due to defects in materials or
workmanship which occurs in normal use. It does not cover the bulb or failure
of the product caused by accident, misuse, abuse, lack of reasonable care,
alteration, or faulty installation, subjecting the product to any but the specified
electrical service or any other failure not resulting from defects in materials or
workmanship. Damage to the product caused by separately purchased, non-
Company brand replacement bulbs and corrosion or discoloration of brass
components are not covered by this warranty.
There are no express warranties except as described above.
THE COMPANY SHALL NOT BE LIABLE FOR INCIDENTAL, SPECIAL OR
CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THE
PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY. ALL
IMPLIED WARRANTIES, IF ANY, INCLUDING IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE
LIMITED IN DURATION TO THE DURATION OF THIS EXPRESS WARRANTY.
Some states do not allow the exclusion or limitation of incidental or
consequential damages, or limitations on how long an implied warranty lasts, so
the above exclusions or limitations may not apply to you.
Call for customer service and/or missing or damaged parts (800-334-6871)
4