Cooper Lighting PQS600R Manual De Instrucciones

PQS600R
ENGLISH
ITEMS REQUIRED
(Purchase separately)
• Phillips screwdriver
• Adjustable wrench
• Pliers
WARNINGS AND CAUTIONS
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, EXPOSURE TO
EXCESSIVE UV RADIATION, OR INJURY TO PERSONS.
IMPORTANT SAFETY INSTRUCTIONS
Lighted lamp is HOT!
WARNING: When using outdoor use portable luminaires, basic safety precautions
should always be followed to reduce the risk of fire, electric shock, and personal injury.
WARNING: To reduce the risk of fire, electric shock, exposure to excessive UV radiation
or injury to persons:
• IMPORTANT: READ ALL SAFETY INSTRUCTIONS.
• Turn off/unplug and allow to cool before replacing bulb.
• Bulb gets HOT quickly! Only contact switch/plug when turning on.
• Do not touch hot lens, guard, or enclosure.
• Do not remain/stand in light if skin feels warm.
• Do not look directly at lighted lamp.
• Keep away from materials that may burn.
• Use only with a 300 watt or smaller quartz halogen bulb.
• Do not touch the bulb at any time. Use a soft cloth. Oil from skin may damage bulb.
• Do not operate the portable luminaire with a missing or damaged guard, lamp containment
barrier, or UV filter.
• If lens is replaced, use only a diffused tempered safety glass of equal thickness.
• Use of bulb(s) of higher wattage rating than what is listed in the safety instructions will void
the warranty.
• For indoor and outdoor use.
• cULus LISTED.
• Connect fixture to a 120 volt, 60 Hz power source. Any other connection voids the warranty.
• Fixture should be installed by persons with experience in household wiring or by a qualified
electrician. The electrical system, and the method of electrically connecting the fixture to it,
must be in accordance with the National Electrical Code and local building codes.
• Use with only three-wire outdoor extension cords that have three-prong grounding plugs
and grounding receptacles that accept the appliance's plug.
• Ground Fault Circuit Interruption (GFCI) protection is to be provided on the circuit(s) or
outlet(s) to be used for the wet location portable luminaire. Receptacles are available having
built-in GFCI protection and are able to be used for this measure of safety.
Questions? / ¿Preguntas ? 1-800-334-6871 ConsumerProducts@cooperlighting.com
PACKAGING CONTENTS / CONTENIDO DEL PAQUETE
A. Light head
Cabezal de la lámpara
B. Safety guard
Protección de
seguridad
C. Stand
Soporte
D. Handle
Manija
E. (3) 300 watt quartz halogen bulbs
(Two located in light head plus
spare bulb stored in handle.)
(3) Bombillas de halógeno
de cuarzo de 300 vatios
(Dos ubicadas en la cabezal
de la lámpara más una
bombilla adicional almacenada
en la manija.)
F. Light bracket
Abrazadera de
la lámpara
• Use only with an extension cord for outdoor use, such as an extension cord of cord type
SW, SW-A, SOW, SOW-A, STW, STW-A, STOW, STOW-A, SJW, SJW-A, SJOW, SJOW-A, SJTW,
SJTW-A, SJTOW, SJTOW-A.
• The worklight should be located no further than 3 feet from the nearest outlet.
• Disassembling your fixture will void the warranty.
• SAVE THESE INSTRUCTIONS.
ASSEMBLING YOUR FIXTURE
WARNING: Deviation from the assembly instructions
may result in a risk of fire or electric shock.
1. Attach light bracket (F) to the stand (C) using (2) hex
bolts (G) and (2) lock washers (H) (Fig. 1).
2. Install the grille guard (B) in the light fixture (A) by
inserting one side of the guard between the frame
and the lens. Squeeze the guard until the other side
can be placed between the opposite side of the
frame and lens.
AIMING THE FIXTURE
WARNING: Risk of burn. Disconnect power and
allow fixture to cool before changing bulb or
handling fixture.
Note: For maximum bulb life, position light so that
the quartz halogen bulb remains within 4 degrees
of horizontal (Fig. 2).
Make sure the light fixture (A) is in the OFF position
and cool. Using the top handle (D), tilt to desired
position (Fig. 3). There is a stop that restricts the
downward and inward movement of the fixture.
• Plug light into a 120 volt receptacle.
• Push red switch to light upper lamp only.
• Push switch a second time to light lower lamp only.
• Push switch a third time to light both lamps.
• Push switch a fourth time to turn fixture OFF.
SPARE BULB INCLUDED
Note: Always handle halogen bulbs with gloves or
with a clean soft cloth. Oil from your skin can cause
premature failure of the bulb.
This fixture includes a spare bulb (E), which insures
that you can always finish your job or project without
interruption due to bulb failure. The spare bulb (E) and
holder are located at the end of the portable base (C).
Simply pull out the black knob on the end of the base
(C) in order to access the spare bulb (E) (Fig. 4).
1
Instruction Manual/ Instrucciones
G. (2) Hex bolts
(2) Pernos hexagonales
H. (2) Lock washers
(2) Arandelas de seguridad
Fig. 1
B
G
H
Fig. 2
Fig. 3
A
Fig. 4
E
D
A
F
C
4˚
D
C