GYS Energy 124 Manual De Instrucciones página 10

Translation of the original instructions
• EAC conformity mark (Eurasian Economic
• Equipment in compliance with British
• Equipment in conformity with Moroccan
• The declaration C‫( م‬CMIM) of conformity is
Mise au rebut :
• This product should be disposed of at an
GENERAL DESCRIPTION
The chargers ENERGY 124 and 126 are designed to charge lead acid batteries with liquid electrolyte, nominal voltage
from 12V (6 elements of 2 V), and with capacity according to the following table:
ENERGY 124
ENERGY 126
OPERATING MODE WITH TESTER FUNCTION
When it is not connected to the mains supply, this charger is a battery tester. It lets you know the state of the battery.
The integrated voltmeter informs you:
• <12.3V : battery to be charged
• between 12.3 and 12.6V : middle charge
• >12.6V : charged
CONNECTION IN CHARGER FUNCTION
Preliminary precautions
• For indoor use, with good ventilation.
• Remove the battery caps if there is, and check the level of liquid. If it is not correct, filled up with distilled water.
Clean well the battery terminals.
• Check if the battery capacity and voltage are compatible with your charger.
Connection and disconnection
• Disconnect from the battery all electronic system during the charge (Do not charge the battery when it is connected
to the vehicle as it may damage the vehicle's on-board electronics).
• Connect the clamps (+ red, - black) to + and - battery terminals, making sure you get a good electric contact,
respecting the following order.
◦ Connect first the battery terminal not connected to the chassis of the vehicle.
◦ Then connect the other connection to the chassis remote from the battery and any fuel line.
◦ At last, plug in your charger to 230 V 50/60 Hz mains supply.
After charging, disconnected the battery charger from supply mains. Then remove the chassis connection and the
battery connection, in this order.
10
ENERGY 124 / 126
Commission)
requirements. The British Declaration of
Conformity is available on our website (see
home page).
standards.
available on our website (see cover page).
appropriate recycling facility. Do not dispose
of in domestic waste.
Current
3A DC
4A DC
Minimum Maximum
10 Ah 45 Ah
15 Ah 60 Ah
EN