Publicidad
Idiomas disponibles
Idiomas disponibles
chaRging pRoceduRe- figuRe B, c, d
note: Charging of the battery pack for the Tiller is identical to the
description below for the Mower.
The battery can be removed from the mower for charging or left in place
1. Remove safety key B-1.
2. Align the charger plug B-2 with the arrow B-4 on top and insert the
charger plug into the receptacle B-3 on the mower (green terminal
to green terminal, white terminal to white terminal) or remove the
battery and insert the charger plug c-1(with the arrow on top) into
the receptacle c-2 on the battery. The charger connector can only
be plugged into the mower receptacle or battery one way.
3. Insert the 120 volt plug d-1 of the charger d-2 into the wall receptacle.
4. The red light d-3 on the charger should come on indicating you
have power and the battery is being charged. Check the charger for
the red light, if it is not on check the charger connector for proper
alignment (step 2). The red light should extinguish and the green
light will come on when charging is complete (takes approximately
20 hours to charge a fully discharged mower).
5. It is recommended to leave the battery on constant charge (between
mowing uses) for optimum performance during the mowing season.
C
This device complies with part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harm-
ful interference to radio communications. However, there is no guaran-
tee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate
the equipment. This Class B digital apparatus complies with Canadian ICES-003.
BatteRY seRvice
When service or repair is required, it is recommended that you take your mower to an authorized Black & Decker Service Center.
When servicing or replacing batteries, please note:
• Use only the same type and size of battery as originally supplied.
• Do not dispose of the batteries in a fire. The cell may explode. See Battery Recycling information below.
• Do not open or mutilate the batteries. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed.
• Exercise care in handling batteries in order not to short the battery with conducting materials such as rings, bracelets, and keys. The battery or
conductor may overheat and cause burns.
the RBRc™ seal (BatteRY RecYcling)
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the lead acid battery (or battery pack) indicates that the
costs to recycle the battery (or battery pack) at the end of its useful life have already been paid by Black & Decker. In some
areas, it is illegal to place spent lead acid batteries in the trash or municipal solid waste stream and the RBRC
program provides an environmentally conscious alternative.
RBRC in cooperation with Black & Decker and other battery users, has established programs in the United States and
Canada to facilitate the collection of spent lead acid batteries. Help protect our environment and conserve natural resources
by returning the lead acid battery to an authorized Black & Decker service center or to your local retailer for recycling. You may also contact
your local recycling center for information on where to drop off the spent battery, or call 1-800-544-6986.
B
D
Publicidad
