Charging A Battery - Black and Decker BXAE00022 Manual Del Usuario

Battery charge
don't start the
charging
process and
no fault
indicator lights
on.
3. Instructions manual
Turn OFF ignition (heating, lighting...) before using
the charger when battery is installed in the vehicle.
Clean the battery terminals before using the
charger.

3.1. Charging a battery

1. Before connecting the charger: make sure that the power supply lead
is not plugged into the mains !
2. Connection to the battery
Connect the outlet cable to the charger.
 Output cable with clamps
Check first if the negative terminal is connected/grounded to the chassis.
If yes: Connect the red clamp (+) to the positive terminal (+) of the battery,
then connect the black clamp (-) to the earth/chassis of the vehicle (a heavy
gauge metal part of the frame or engine block. Do not connect to the
carburetor or fuel lines).
If not: For a positive-grounded vehicle (very rare case or old-timer), connect
the black clamp (-) to the negative terminal (-) of the battery, then connect the
red clamp (+) to the earth/chassis of the vehicle (a heavy gauge metal part of
the frame or engine block. Do not connect to the carburetor or fuel lines).
 Output cable with rings
Loosen and remove each nut from the bolts at the battery terminals. Connect
the positive ring (+) to the positive terminal (+) of the battery, then connect the
negative ring (-) to the negative (-) terminal of the battery. Replace and tighten
back the nuts to secure them.
In both cases: make sure that the charger outlet lead make tight connections.
3. Connection to the mains
Plug the power supply lead of the battery charger into the mains.
The power LED "ON" is lighting up green = "Stand by" mode.
4. Selection of the charging mode
Press the button once to activate the unit, and then choose the charging
parameters, for the type of battery and the charging current by pushing the
selection push button. The charging process will start automatically.
Leads disconnected, leads
short-circuited.
Battery completely
circuited.
Position
correctly and start charging
the battery again.
short- The battery may be defective.
Contact your battery service
center.
7
the clamps/rings