Casals CAG20/180S Manual De Instrucciones página 10

IMMERSE IN WATER OR ANY OTHER LIQUID.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- If the appliance is not in good condition of clean-
liness, its surface may degrade and inexorably
affect the duration of the appliance's useful life
and could become unsafe to use.
SPECIFICATIONS:
CAG20/180S
2000W
Rated Power
230-240V
Rated voltage
8500rpm
No load speed
180mm
Disc diameter
M14
Spindle thread
5,1 kg
Weight
- Sound Pressure 94dB(A)
level (LpA) = KpA=dB
97dB(A)
- Sound Power
KWA=dB
level (LwA) =
2,8 m/s
Vibration=
NB: These specifications are subject to change without notice of purpose of improvement.
NB: By virtue of the conditions of fabrication of this product, the maximum absorbed power can differ
from that specified.
NB: By virtue of the conditions of fabrication of this product, the maximum used power can differ from
that specified.
WEAR HEARING PROTECTION
- Measured sound level determined according
EN60745
- The vibration emission level given in this infor-
mation sheet has been measured according
EN60745 and may be used to compare one
tool with other. It may be used for a preliminary
assessment of exposure
- The vibration value during actual use of the
SUPPLIES
- Always use original supplies, designed specifi-
- These supplies are available in specialist shops.
ANOMALIES AND REPAIR
- Take the appliance to an authorised technical
- If the connection to the mains has been
CAG20/230S
2000W
230-240V
6500rpm
230mm
M14
5,3 kg
94dB(A)
KpA=dB
97dB(A)
KWA=dB
K=m/s 2,8 m/s K=m/s
2 2 2
- It's necessary identify safety measures to
cally for your appliance model.
support service if a product damage or other
problems arise. Do not try to dismantle or repair
without assistance, as this may be dangerous.
damaged, it must be replaced and you should
proceed as you would in the case of damage.
CAG24/230S
2400W
230-240V
6500rpm
230mm
M14
5,7 kg
94dB(A)
KpA=dB
107dB(A)
KWA=dB
2,8 m/s K=m/s
2 2 2
power tool can differ from the declared total va-
lue depending on the way in which tool is used
protect the operator that are based on an esti-
mation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is swit-
ched off and when it is running idle in addition to
the trigger time).
CAG26/230S
2600W
230-240V
6500rpm
230mm
M14
6 kg
94dB(A)
KpA=dB
107dB(A)
KWA=dB
2,8 m/s K=m/s
2 2