Fitting/Removing Attachments - Russell Hobbs 21501-56 Manual De Instrucciones

Read the instructions, keep them safe, pass them on if you pass the appliance on. Remove all
packaging before use.
A IMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
1 This appliance can be used by persons with reduced physical,
sensory or mental capabilities or lack of experience and
knowledge if they have been supervised/instructed and
understand the hazards involved.
• Children must not use or play with the appliance.
• Keep the appliance and cable out of reach of children.
s Misuse of the appliance may cause injury.
2 Unplug the appliance before assembly, disassembly, or cleaning.
3 Don't leave the appliance unattended while plugged in.
4 If the cable is damaged, it must be replaced by the manufacturer,
its service agent, or someone similarly qualified, to avoid hazard.
L Don't put the handle in liquid.
5 Don't use the wand in hot oil – even moderately hot oil can cause a nasty burn.
6 Don't try to chip ice, don't try to chop raw meat, and take great care with the blades.
7 Don't fit an attachment or accessory other than those we supply.
8 Don't use the appliance for any purpose other than those described in these instructions.
9 Don't operate the appliance if it's damaged or malfunctions.
T Don't run the motor for more than 1 minute at a time, then leave it for a minute to cool down
before using it again.

5 FITTING/REMOVING ATTACHMENTS

1 Unplug the appliance before fitting or removing attachments.
2 Push the end of the handle into the attachment, and turn the handle to the right.
3 To remove the attachment, turn the handle to the left, and lift it off the attachment.
C SWITCH ON
4 Put the plug into the power socket.
5 Press the switch to start the motor, release it to switch off.
household use only
2