Publicidad
Idiomas disponibles
Idiomas disponibles
TE-Series PRO Channels
Cautions, Warnings, FCC
CAUTIONS
CAUTION – RISK OF SHOCK –
Disconnect Power at the main
circuit breaker panel or main
fusebox before starting and
during the installation.
WARNING
• This fixture is intended for
installation in accordance with the
National Electrical Code (NEC)
and all local code specifications.
If you are not familiar with
code requirements, installation
by a certified electrician is
recommended.
• This lighting fixture is suitable for
indoor use, dry or damp locations.
• The LED light output is strong
enough to injure human eyes.
Precautions must be taken to
prevent looking directly at the LED's
with unaided eyes for more than a
few seconds.
• Supply leads and interconnects
are not listed for in-wall use. In-
wall rated wire may be purchased
separately. Read all instructions
thoroughly before starting
installation.
Please see previous page for channel installation instructions
We're here to help
FCC Information:
This device complies with part 15 of
the FCC Rules. Operation is subject
to the following two conditions:
1. This device may not cause
harmful interference, and
2. This device must accept any
interference received, including
interference that may cause
undesired operation.
Note: This equipment has been
tested and found to comply with the
limits for a Class B digital device,
pursuant to part 15 of the FCC
Rules. These limits are designed
to provide reasonable protection
against harmful interference in
a residential installation. This
equipment generates, uses and
can radiate radio frequency energy
and, if not installed and used in
accordance with the instructions,
may cause harmful interference
to radio communications.
However, there is no guarantee
that interference will not occur
in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and
on, the user is encouraged to try to
correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between
the equipment and receiver.
• Connect the equipment into an
outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an
experienced radio/TV technician for
help.
866-558-5706
Hrs: M-F 9am to 5pm EST
Publicidad
