GYS POWERDUCTION 160LG Manual De Instrucciones página 22

Translation of the original instructions
COOLING CIRCUIT AND «FORCED COOLING» MODE
When the coolant temperature reaches 35 °C (95 ° F), the fan will turn on. As soon as it goes below 35 °C, it cuts.
During long periods of use, the POWERDUCTION has a forced cooling mode. To activate it :
1. Set the main switch (1) to ON.
The machine initialises in 2 seconds.
2. Press the activation button (2). The indicator on button (2) and the lance support LED (12) both switch on, indicating
that the machine is ready to operate.
3. Hold (>3 seconds) the button (10). The « Forced cooling» mode is activated.
The cooling fan then starts automatically. The cooling fan will be audible and the «Fan ON» message will appear on the
display.
To stop the «Forced cooling», press the activation button to stop the heating or hold the button (10) again. The message
«Fan OFF» is displayed.
MAINTENANCE
General recommendations
• It is recommended to change the cooling liquid every two years, otherwise you may damage the Powerduction's lance.
• It is essential that the maintenance of the product is performed by qualified, authorised staff, that is fully aware of the
recommendations outlined in this manual.
• Never clean, lubricate or perform maintenance on the product when it's being used.
• Before any maintenance work, set the On / Off switch to « 0 » to switch off the machine, .then disconnect it it from
the mains power supply to prevent any electrical shock or other risks resulting from improper handling.
• Do not wear rings, watches, jewellery, hanging clothes (e.g. ties), torn clothes, scarves, unbuttoned or unzipped
jackets, or anyhting that could get caught during the operation of the machine
7 Nm
COMPLETE INDUCTOR 70° POWERDUCTION 160LG
Preventive maintenance
Meticulous inspections should be carried out at regular intervals to quickly detect and eliminate faults, so they will not
cause damage to the device.
22
POWERDUCTION 160LG
• Rather wear clothing specifically designed for the prevention of accidents, such as:
non-slip shoes, anti-noise helmets, protective goggles, safety shoes, etc ...
• Never use petrol or flammable solvents to clean the product. Prefer the use of wa-
ter and, if necessary, non toxic commercial solvents.
• After maintenance, always put and secure the metal covers back on, before swit-
ching the machine on.
• The ferrite on inducer can be replaced if damaged.
ACCESSORIES (INCLUDED)
Complete inductor 90° powerduction 160LG
056862
OPTIONS
059771
EN