Warnings; Set Up Travel Cot; Set Up Bassinet - Joie allura Manual De Instrucciones

WARNINGS

!
Adult assembly required.
!
Please save instruction manual for future reference.
!
Read all the instructions in this manual before using product.
!
Discontinue using travel cot when child reaches 15 kg (approximately 86 cm in height) or is able to
climb out.
!
Discontinue using bassinet when child can sit, kneel or roll over or pull itself up.
!
The lowest position of the mattress is the safest and the base shall always be used in that position as soon
as the baby is old enough to sit up.
!
Failure to follow these warnings and instructions could result in danger.
!
DO NOT make any modifications to this travel cot or use it with component parts from other manufacturers.
!
Warning: Do not use the cot if any part is broken , torn or missing and use only spare parts approved by the
manufacturer.
!
NEVER leave your child unattended. Always keep your child in view.
!
Use the travel cot with only one child at a time.
!
Do not use more than one mattress in the travel cot.
! Once the bassinet is installed, DO NOT place child under the bassinet.
!
DO NOT leave anything in the travel cot or place the travel cot close to another product, which could
provide a foothold or present a danger of suffocation or strangulation, e.g. strings, blind curtain cords etc.
!
Always use travel cot on a flat, level floor.
!
Be aware of the risk of open fire and other sources of strong heat such as electric bar fires, gas fires, etc in
the near vicinity of the travel cot.
!
To avoid strangulation, DO NOT place items with a string around your child's neck, suspend strings from this
product, or attach strings to toys.
!
All assembly fittings should always be tightened properly and that fittings should be checked regularly and
retightened as necessary.
!
Regularly inspect the product for damaged hardware, loose joints, missing parts or sharp edges.
!
DO NOT move the travel cot with your child in it.
!
Make sure the product has been folded or unfolded completely before letting your child approach
the travel cot.
!
You must attend to your child while it is in the bassinet. Do not place the bassinet in a dangerous place.
!
Do not replace Joie mattress with other mattress or soft pad.
!
Should the padded rim be split or bitten through to expose the padding, do not use the travel cot.
!
The cot is ready for use only when the locking mechanisms are engaged and to check carefully that they are
fully engaged before using the folding cot.
!
Always keep accessories out of child's reach. Remove the accessories when child is able to pull itself up in
the travel cot.
!
DO NOT use the bassinet as a napper before assembling with mattress.
!
DO NOT store the bassinet in the travel cot while not in use.
! You must follow the instructions in this manual when using the travel cot and the bassinet.
!
To avoid suffocation, remove plastic bag and packaging materials before using this product. The plastic bag
and packaging materials should then be kept away from babies and children.
!
Only use the mattress sold with this cot, do not add a second mattress on this one, suffocation hazards.
7

Set Up Travel Cot

Please read all the instructions in this manual before setting up and using this product.
1. Undo the three hook and loop fasteners.
1
2. Pull the top rails up until both become rigid. If not rigid, pull up again until they are rigid.
!
If top rails do not latch, raise the center of floor halfway up, and then pull up again to latch the rails.
3. Latch the low rails.
3
4. Push the center of floor down. 4
!
Be sure all rails have locked before lowering center.
5. Install mattress. 5
!
Install mattress, soft side up.
6. See image
6

Set Up Bassinet

Tip
Before setting up bassinet, make sure all rails have become rigid.
The bassinet must be fully assembled and installed before using, including eight bassinet clips,
two metal tubes, and mattress.
1. Position the bassinet clips over and down into the edges of the travel cot.
!
Be sure all bassinet clips are secured in place by pushing down firmly on each bassinet clip
until all are snapped into place.
2. Assemble the two metal tubes by inserting them into the tunnel flaps provided on the bottom
of the mattress.
8
3. Place the mattress into the bassinet.
9
!
Place mattress, soft side up.
The installed bassinet is shown as 10
2
7
8