Hamilton Beach Smart Lift 14401 Manual De Instrucciones página 5

840174302 ENnv01.qxd:Layout 1
To Steam Iron
1
5
9/10/09 10:11 AM Page 5
AUTOMATIC SHUTOFF:
Your iron is equipped with a feature which can be used to turn off iron heat when iron is not in use (see
chart below). On certain models, this auto shutoff feature will only activate when the AUTO OFF/STAY ON Switch is in the "AUTO
OFF" position. If the iron turns off automatically, it will begin to heat again when the iron is moved. NOTE: If you wish to deactivate
this feature, slide the switch to the "STAY ON" position. The iron will then stay in the heating mode until turned OFF or unplugged.
Iron Position
Face Down (soleplate touching any surface or if tipped over/fallen on side)
Upright (resting on heel or Smart Lift feature)
2
The AUTO OFF/STAY ON Switch is an
optional feature on select models only.
OR
5
Hold iron six inches from garment. Do not
allow hot soleplate to touch delicate garments.
Auto Standby
30 seconds
15 minutes
3
Select desired temperature. Allow 2 minutes
for iron to reach desired temperature before
using. See Fabric Setting Chart.
6
Pull Smart Lift Trigger to activate the Smart
Lift™ feature, as shown in Step 5 of "To Dry
Iron."
4
Set Adjustable Steam Lever to On. Steam will
automatically stop when Smart Lift Trigger is
activated.
7
Press down on iron to lock Smart Lift feature
back into place.
5