Operation; Turning On And Off; Trimmer Settings - Grizzly Tools CT 2000 Li Traducción Del Manual De Instrucciones Original

GB
Replacement plastic blades can be
found in the storage box (
the additional handle (
To put on the auxiliary handle:
4. Unscrew and remove the pre-
assembled quick-release lever
(25) of the additional handle (5).
5. Pull the ends of the auxiliary
handle (5) to extend the handle
and slide it over the handle
holder (26). The holder for the
spare spool (4) points upwards.
6. Screw the additional handle (5)
to the quick-release lever (25).
7. Lock the quick-release levers
(25) by pressing them in the di-
rection of the bar (1).
They must fit the additional
handle (5) so that a tensioning
with medium force can be car-
ried out.
Otherwise, the quick-release
levers (25) must be turned
clockwise for tensioning them or
anti-clockwise to loosen them.

Operation

Caution: risk of injury! Do not
operate the appliance without
the protective cover. To oper-
ate the appliance, wear suitable
clothing, eye and ear protection.
Prior to every use, check that
the appliance is operative. Do
not block the On/Off switch or
the switch lock. They must reli-
ably turn off the motor when you
release the switch. Do not oper-
ate the appliance if one of the
switches is damaged.
62
5a) on
5).
1. To turn on, use your thumb to actuate
the switch lock (3), then press the On/
Off switch (2). Release the switch lock.
2. To turn off, release the On/Off switch
(2). There is no continuous operation
mode.
To adjust the auxiliary handle:
The auxiliary handle can be set to various
positions. Adjust the handle so that the
cap is tilted slightly forward as you work
(see picture below "cutting grass").
Loosen the screw (25) in the handle

and move the auxiliary handle (5)
to your favourite position. Tighten
the screw in the handle. The latch-
ing steps integrated into the holder
prevent the handle changing position
unintentionally.
Please observe local regulations
concerning noise protection.

Turning on and off

Maintain a firm stand and hold the
appliance well with both hands and
at some distance away from your
body. Before turning on the appli-
ance, check that it will not touch
any objects.
After turning off the appliance,
the trimming assembly will keep
revolving for some time. Allow
the trimming assembly to come
to a standstill. Keep hands and
feet away. Risk of injury!
Remove grass cuttings regularly
from the cutting unit to make sure
that cutting is not impaired.

Trimmer settings