Trouble Shooting - Grizzly Tools CT 2000 Li Traducción Del Manual De Instrucciones Original

GB

Trouble shooting

In the event of an accident or malfunction, remove the battery from the device
immediately! Failure to comply may result in injuries from cuts.
Problem Possible cause
Battery (
Appliance
Battery (
won't start
On/Off switch (
Motor defective
Internal loose contact
Intermittent
operation
On/Off switch (
Cutting insert (
Much
vibration
Trimming assembly dirty
Loud noise
Motor defective
Cutting insert (
Trimming assembly dirty
Bad trim
Battery (
charged
66
17) discharged
17) not in
2) defective
2) defective
22) broken
22) broken
17) not fully
Corrective action
Recharge battery (
separate operating instructions for the
rechargeable battery and charger)
Insert battery ( 17) (Observe the se-
parate operating instructions for the
rechargeable battery and charger)
Send in to Service Centre for repair
Send in to Service Centre for repair
Replace cutting insert (
(see „Cleaning and maintenance")
Clean trimming assembly
(see „Cleaning and maintenance")
Send in to Service Centre for repair
Replace cutting insert (
(see „Cleaning and maintenance")
Clean trimming assembly (see „Clean-
ing and maintenance")
Recharge battery (
separate operating instructions for the
rechargeable battery and charger)
17) (Observe the
22)
22)
17) (Observe the