Weston 65-0501-W Manual Del Usuario página 3

WARNING!
appliance, make sure the appliance is OFF and the PLUG IS REMOVED
FROM THE OUTLET/POWER SOURCE!
Some parts of the Vacuum Sealer may need
replacing after repeated use. A Maintenance
Kit (Sold Separately) (Figure 1) may be
necessary for the Vacuum Sealer to properly
function. NOTE: Remove the inner foam oval
from all of the foam Chamber Seals. The foam
oval can be discarded, only the outer foam ring
is needed (Figure 1a).
REPLACING THE VACUUM
CHAMBER SEAL:
1. Press the ON/OFF Button on the Control
Panel to turn the Vacuum Sealer "OFF".
2. Disconnect the Vacuum Sealer from the
power supply.
3. Make sure the Vacuum Sealer is completely cool.
4. Press both
Release Buttons on each side
of the Vacuum Sealer to release
the lid lock, then lift the Vacuum
Lid to open.
5. Remove the
Chamber Seal (NOTE: The
Vacuum Chamber Seal DOES
NOT have an adhesive backing.)
(Figure 2) from the groove
around the Vacuum Chamber
on the base of the Vacuum
Sealer.
6. Position a new Vacuum
Chamber Seal into the groove
around the Vacuum Chamber
on the base of the Vacuum
Sealer.
7. Work the Vacuum Chamber
Seal into the groove until the
seal is completely in place.
SERVICE INSTRUCTIONS
Before cleaning, assembling or disassembling the
of the Lid
Vacuum
Vacuum
Chamber
Seal
Seal Bar
Heating
Element/
Seal Bar Tape
-3-
Figure 1
Vacuum Sealer
Maintenance Kit
Figure 1a
Discard
foam
ovals
Keep
Chamber
Seals
Figure 2
Vacuum
Chamber