Weston 65-0501-W Manual Del Usuario página 5

REPLACING THE LID ASSEMBLY:
1. Press the ON/OFF Button on the Control Panel to turn the Vacuum Sealer "OFF".
2. Disconnect the Vacuum Sealer from the power supply.
3. Make sure the Vacuum Sealer is completely cool.
4. Press both of the Lid Release Buttons on each side of the Vacuum Sealer to
release the lid lock, then lift the Vacuum Lid to open.
5. Using a Phillips-head screwdriver, remove the 4 Lid Screws in the Plastic Lid
Base (Figure 4).
NOTE:
Short, narrow diameter or angled screwdrivers work best for removing
the screws.
6. Remove the Plastic Lid Base, 2
Release Buttons and the 2 Release
Springs from the Stainless Steel Lid.
7. To install the new Lid Assembly,
turn the Plastic Lid Base upside down
with the Vacuum Chamber Lid Seal
positioned towards the front of the
Vacuum Sealer and the Chamber Lid
Seal facing you.
8. Place the 2 Release Buttons into
the slots (Figure 5). Insert the 2 Release
Springs into the backs of the Release
Buttons.
9. With the Vacuum Chamber Lid
Seal positioned towards the front of the
Vacuum Sealer and the Chamber Lid
Seal facing you, carefully position the
Plastic Lid Base Assembly back onto
the Stainless Steel Lid so that the 4
screw holes in the Plastic Lid Base
line up with the 4 screw posts on the
Stainless Steel Lid.
10. Use one hand to hold the Plastic Lid
Base and the other to insert and turn the
4 Lid Screws. HINT: It may work better
to tilt the Vacuum Sealer on its side when
installing the Lid Screws.
11.When all 4 Lid Screws are installed,
the Plastic Lid Base should be flush
to the Stainless Steel Lid. If it is not,
then the Lid Screws may be improperly
installed (i.e. crooked or not tight enough).
Release Button
Release Spring
Chamber Lid Seal
Plastic Lid Base
Stainless Steel Lid
Screw
Posts
-5-
Lid Screws
Figure 4
Figure 5