Set Up Usb Communications Hub; Set Up Main Unit - Oregon Scientific I300 Manual De Uso

• Position the sensor so that it faces the USB
Communications Hub and main unit, minimizing
obstructions such as doors, walls and furniture.
• Place the sensor out of direct sunlight and moisture.
• Place the sensor in a location with a clear view to the
sky, away from metallic / electronic objects.
• Position the sensor close to the USB Communications
Hub and main unit during cold winter months as below-
freezing temperatures may affect battery performance
and signal transmission.
TIP The transmission range may vary depending on
many factors. You may need to experiment with various
locations to get the best results.
NOTE Use alkaline batteries for longer usage and
consumer grade lithium batteries in temperatures below
freezing.

SET UP USB COMMUNICATIONS HUB

NOTE Set up the remote sensor before installing the USB
Communications Hub.
For continuous use, always connect the USB
Communications Hub to the computer using the USB
cable provided.
There is a registration mode with the main unit when
the USB Communications Hub is turned on the first
time, or after each installation. Users can also force a
registration.
To register with the main unit:
• Press and hold SEARCH at the back of USB
Communications Hub to enter registration mode.
• Press and hold
enter registration mode.

SET UP MAIN UNIT

NOTE Set up the remote sensor and USB Communications
Hub before installing the main unit.
1. Remove the battery compartment cover.
2. Insert the batteries, matching the polarities.
6
+ at the back of main unit to