Change Settings; Table Stand Or Wall Mount; Remote Sensors; Set Up Sensor - Thr268 - Oregon Scientific BAR888RA Manual Del Usuario

UNIT
Main Indoor Temperature Area
Remote Outdoor Temperature Area

CHANGE SETTINGS

1. Press and hold MODE for 2 seconds to enter setting
mode.
2. Press or to change settings.
3. Press MODE to confirm.

TABLE STAND OR WALL MOUNT

The table stand is in the back of the product. See below
for how to assemble the table stand.
CHANGE SETTINGS
2
1
3
LOCATION
4
To mount the product on a wall, put the stand inside
the back of the unit and then place it on a wall, as shown
below.
2
1

REMOTE SENSORS

This product is shipped with 2 sensors: THR268 and
THN122N Thermometer Sensors that collect
temperature data. Data can be collected from up to 3
sensors. Additional sensors sold separately.

SET UP SENSOR - THR268

1. Assign a different channel to each remote sensor
by changing the channel switch in the battery
compartment of the remote sensor.
2. Select the units of measurement for the temperature
display on the °C/ °F slide switch.
3. Install the batteries strictly according to the polarities
shown.
5
4
3