Installation Example - Vetus LGS Serie Instrucciones De Instalación

Sending unit for the temperature alarm
A sending unit for the temperature alarm can be installed in the
exhaust hose of the motor.
Maintenance
All hose connections should be inspected on a regular basis to
ensure that they are both gastight and watertight.
Before the boat is put into storage for the winter the exhaust
gas / cooling water separator should be drained by opening the
outboard valve in the drainage pipe.
1
LGS 40/ 45/ 50
LGS 60/ 75
2
LGS 40/ 45/ 50
Exhaust gas / cooling water separator LGS

Installation example

The illustration shows an exhaust system with an exhaust
muffler (type LP) the exhaust gas / cooling water separator
(type LGS) an transom exhaust connection and a cooling water
drainage pipe.
The entry of water running up from behind is almost totally
prevented by the additional height difference between the water
line and the exhaust gas / cooling water separator.
After the motor is shut down, the water still in the exhaust hose
(between the highest point of the exhaust system and the
exhaust muffler) will run back down to the exhaust muffler.
To limit the quantity of water which runs back down to the
exhaust muffler as much as possible, the exhaust gas / cooling
water separator should be installed as close to the exhaust
muffler as possible.
The water in the exhaust gas / cooling water separator will drain
away via the skin fitting until it reaches the same level as the
waterline.
LGS 60/ 75
ENGLISH
5
030411.02