Tabla de contenido
Publicidad
ASSEMBLING INSTRUCTION
Oscillation knob
Motor
Control box
Power cord
Screw B
Extension tube
Out – joint
Stand cover
Screw A
Stand base
TECHNICAL DATA
Rated voltage
Max. power consumption
USING STAND FAN
1. Put spring in stand tube from the tube bottom, tighten stand tube to stand base with screw A.
2. Unscrew the base screw by turning clockwise from the stand pole, and put the base screw through
the cross base to stand pole by turning counter clockwise then tighten the base and the extenslon
pole.
3. Put the base cover on the stand base. Pull the extenslon pole out then tighlen the out – joint again.
4. Place control box firmly on top of extension pole, tighten sorow B.
Front gril
Blade
Rear gril
Shaft
: 220 - 240 V ~, 50 Hz
: 50 W
Nut
Cap
Switch
Plastic foot
Rubber foot
4
1. Extension tube
2. Out – joint
3. Stand
4. Front base
5. Base
6. Fixing plate
7. Screw shaft
Publicidad
Tabla de contenido
