Monster iSport VICTORY Manual De Instrucciones página 6

More Features
Battery Indicator
When the headphone is connected to a device with
iOS system, a battery indicator will appear at the
upper right of the system, indicating battery status
of the headphone.
Auto Power-Off
When the distance between the headphone and
the mobile phone is beyond effective range, a
warning tone will be alerted and headphone will try
to reconnect with the mobile phone for 10 minutes.
If no phone is reconnected within 10 minutes, the
headphone will go to connectable mode and wait
for 5 more minutes before automatically power off.
Automatic Connection After
Powering On
When the headphone and phone have been
paired once, they will automatically connect when
the headphone is on and Bluetooth is activated
on the phone.
Connection Standby
After successful pairing and connection, you will
hear the voice prompt "Phone 1 connected". The
headphone will be in turning on mode or standby
mode automatically and the blue LED will flash
once every 5 seconds. When the phone disconnects
the headphone, you will hear the disconnect tone.
Reset Paired Device(s)
Go to the Pairing mode (hold the Multifunction
button for 5 seconds from Power off state), then
hold the Volume "-" to reset the paired device(s),
indicator light flashes blue and red alternatively
and rapidly few times, you will also hear the tone.
Hardware Reset
Plug the Micro USB cable into the USB micro port
of headphone to connect it to the computer or
other device made for USB charging to have the
hardware reset.
Certification
FCC ID: RJE190671
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any
interference received, including interference
that may cause undesired operation. Changes or
modification not expressly approved by the party
responsible for Compliance could void the user's
authority to operate the equipment. Connecting of
peripherals requires the use of grounded shielded
signal cables. The socket-outlet shall be installed
near the equipment and shall be easily accessible.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
CAUTION: Changes or modifications not expressly
approved by the party responsible for compliance
could void the user's (or your) authority to operate
the equipment. Avoid storage in extreme heat
or cold. Avoid exposure to liquids, temperature
extremes and high humidity. The product's
working temperature range is 0–45°C (32–113°F).
This device complies with FCC/IC radiation
exposure limits set forth for an uncontrolled
environment.
Canada Notice — IC ID: 5153A-
190671
This Class B digital apparatus complies with
Canadian ICES-003.
This device complies with RSS 210 of Industry
Canada. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference and (2) this device must accept any
interference,including interference that may cause
undesired operation of the device.
Canadian Class B Statement
This digital device does not exceed the Class
B limits for radio noise emissions from digital
apparatus as set out in the interference causing
equipment standard entitled "Digital Apparatus, "
ICES-003 of the Department of Communications.
CAN ICES-3 (B)/NMB-3(B)
Modification
Any changes or modifications not expressly
approved by the grantee of this device could void