EarthWise LSTM2012-4 Manual Del Propietário página 4

UNPACKING
This product requires some assembly.
PACKING LIST
- String Trimmer
- Safety Guard
- Mower Deck
- Front/Auxiliary Handle
- Charger and Battery Pack
- Owner's Manual
- Hardware Bag
WARNING: Do not install battery until assembly is complete.
Failure to comply could result in accidental starting and possible
serious personal injury.
WARNING: If any parts are damaged or missing do not operate
this product until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
Carefully remove the product and any accessories from the box.
Make sure that all items listed in the packing list are included.
Inspect the product carefully to make sure no breakage or damage
occurred during shipping.
Do not discard the packing material until you have carefully
inspected and satisfactorily operated the product.
If any parts are damaged or missing, please call 1-800-633-1501
for assistance.
ATTACHING THE GUARD
WARNING: Do not operate the trimmer without the guard attached.
Always wear gloves when mounting or replacing the guard.
Be careful of the blade on the guard and protect your hands
from being injured by the blade.
Position the guard on the trimmer, then attach the guard with the
supplied screws. (Fig.2）
NOTE: A guide wheel is pre-mounted on the guard to make
the edge-cutting function easier.
ATTACHING THE AUXILIARY HANDLE

Place one ribbed hole at the base of
the auxiliary handle over the knob
located at the lower portion of the
rear handle.

Press the other ribbed hole over the
knob on the other side of the rear
handle.(Fig.3.)

Screw the front handle firmly into
place with the ST 4.2 X 18 screw included. (Fig.4)

You can easily adjust the handle by pressing both sides of
the knobs at the same time. (Fig 5)
ASSEMBLY
HEIGHT ADJUSTMENT
The overall height of the trimmer can be adjusted. Release the
clamp on the tube. The tubes can then be adjusted shorter or
longer. When the desired height is achieved, lock in place with the
clamp. (Fig.6)
CHANGING THE WORKING ANGLE
The trimmer can be set in any of five different operating
angles. Press and hold the
locating button. Set the
desired operating angle.
Angle positions 1 and 2 are
for edge cutting. 3,4 and 5
Angle positions are for
normal cutting. Release the
locating button. (Fig.7)
ATTACHING THE STRING TRIMMER TO MOWER DECK

Slide the bottom of the trimmer head (A) into the front of the
trimmer pocket (B) and slightly rotate trimmer guard down into
the pocket until it snaps fully into place as shown in Fig. 8. If
trimmer has a wire guide (C) and/or wheeled edge guide (D),
wire guide should be flipped up and wheeled edge guide
should be above the deck.
Fig. 8
F
B
NOTE: Ensure the cutting line is underneath the deck and not
protruding out the top.

Using the string trimmer auxiliary and rear handles, lift up the
string trimmer and ensure the mower deck is securely attached.

To remove the string trimmer from the mower deck, step on the
release lever (F) and lift the trimmer out.
CAUTION: Depending on setting of the string trimmer's working
angle and/or the battery pack used with the mower deck, the
assembly may become unbalanced. Care should be exercised when
using on uneven ground or slope.
INSTALLING AND REMOVING BATTERY PACK FROM THE UNIT
Slide the battery pack into the
string trimmer (see illustration).
Ensure the battery is securely
connected. To remove the
battery, depress the release
button and slide battery pack
out of tool.(Fig.9)
4
LSTM2012-4
A
C
Fig. 9
D