Remington MicroScreen3 TCT Manual De Instrucciones página 3

Cleaning your shaver:
TO ASSURE OPTIMAL PERFORMANCE,IT IS RECOM-
MENDED T H AT YOU CLEAN YOUR SHAVER AFTER EACH
USE.The cutting system of this shaver was designed
to be cleaned by rinsing under warm running water or
by b r u s h i n g .
Cleaning your Remington ® MicroScreen ® 3 TCT
easy.
(NOTE: With the MS3-4000,MS3-4500 and MS3-0004
model,the brush icon will blink to remind
you to clean your shaver.)
Remove the shaver head by
squeezing on both side buttons and
pulling away from the body of the
shaver. You may blow out the stubble
thoroughly, or rinse the shaver head in water.
Important: Never clean the screen
with the enclosed brush as damage
may occur to the holes in the screen.
At least once a week,the cutters and
the trimmer should be cleaned with the
cleaning brush. You can also rinse the
cutter under running water, like the screen.
Caution: Never put the shaver completely under water.
Do not use any aggressive cleansing agent as this ma y
destroy the shaver coatings.
To clean and lubricate your shaver's
cutters and head assembly, apply
Remington Shaver Sav e r ® ( S P - 4 )
L u b r i c a n t . The lubricant helps remove
hair clippings while reducing wear. A
quick spray after each shave keeps your shaver
operating at peak
performance.
Caution: Do not remove or replace the head assembly while shaver
is running as it may cause damage to the unit's screens or cutters.
Worn or damaged parts should be replaced with Remington
replacement parts only.
Replacing Screens and Cutters
® Shaver is
Because they are subject to daily use,the cutters and screens
of your Remington
e v e n t ually require replacement to maintain a close,comfortable
s h av e . Depending on your shaving technique and hab i t s ,t h e
screens will usually last six months; the cutters,one year. (Note:
Model MS3-4000,MS3-4500 and MS3-0004,the screen icon will
blink when it is time to replace the screens). Some signs that your
screens and cutters need replacing are:
Irritation. As screens get worn,you may notice your skin feels
more sensitive after a shave,particularly when you apply aftershave.
Pulling. As cutters wear, your shave may not feel as close,and
you may feel your shaver is pulling at your whiskers.
Wear-through. You may notice that the cutters have worn
through the screens.
To prevent inadvertent damage to the Screen and Cutter
Assembly, do not attempt to remo ve them unless you are
replacing them. To remove the old screens and cutters follow the
instructions that come with the screen and cutter replacement
package. It's always a good idea to replace the screens when you
replace the cutters.
®
® MicroScreen ® 3 TCT ® Shaver will wear and
To Replace a Cutter Assembly That is Removed
Unintentionally:
Hold the assembly in the middle of
the "T".
Gently slide the plastic portion of the
cutter assembly over the top of the
oscillator tip.
Do not push downward on the ends of
the cutters,as you may bend the cutter,
reducing its ability to operate smoothly.
Do not remove cutters from the plastic
pieces to which they are attached,as you
may damage the assembl y.