Aiwa XP-R207 Instrucciones De Operación página 5

H
1
3
I
J
K
2
ENTER/DISP
V
V
V
V
PLAYBACK → H
Connect the supplied headphones to the PHONES/LINE OUT jack.
1 Release HOLD.
2 Place a disc.
3 Press ePLAY/PAUSE.
Playback starts from the first track.
a track number
b elapsed playing time
Basic operation
To stop
To pause
To search for the beginning of a track
To locate a desired passage
Display during playback → I
Press ENTER/DISP during playback to change the display as follows.
1 Track display and elapsed playing time (normal display)
V
2 Track display and remaining playing time of the track in play
V
3 Remaining number of tracks and remaining playing time
The time is not displayed in following cases.
• When trying to program tracks beyond No.32.
• When the total remaining time of the programmed tracks is over 100 minutes.
E•A•S•S PLUS (Electronic Anti-Shock System) → J
The E•A•S•S PLUS function reduces skipping or muting of the sound when the
unit is subjected to shocks.
The player keeps about 48 seconds or 12 seconds of playback sound in its
memory.
To keep 48 seconds in the memory, set the E•A•S•S switch to 48.
To keep 12 seconds in the memory, set the E•A•S•S switch to 12.
To cancel the E•A•S•S PLUS function, set the E•A•S•S switch to OFF.
Note
• Before jogging with this unit, allow sufficient time for the memory buffer to fill up
completely (ideally 40 to 48 seconds).
Continuous shock or vibration may cause the sound to be interrupted even if
the E•A•S•S PLUS function is activated. This is normal and not a malfunction.
Should you experience an interruption in sound, stabilize the unit for a few
seconds, then resume your activity.
• When the E•A•S•S switch is slid during playback, the unit will pause for about
2 seconds.
• When you set the E•A•S•S switch to the 12 or OFF position, the quality of the
sound will be better than the case that you set it to the 48 position.
Resume function → K
Set the HOLD switch to RESUME.
appears, and you can start playback from the point where you stopped
playback by pressing sSTOP/OFF/CHARGE.
When the resume function is on, all-track repeat is selected automatically.
To cancel resume play, set the HOLD switch to OFF.
Note
• Resume play may start at a point about 30 seconds behind or ahead the stopped
point. Resume play may not operate if you stopped at the last 30 seconds of
the final track.
• Resume play will be canceled if you open the disc compartment. If the unit is
turned off, resume play will not be canceled. In this case, be sure to set the
HOLD switch to OFF before changing discs.
Random play → K
Press PLAY MODE while in standby mode to display
Tracks on the disc are played in random order.
To cancel random play, press PLAY MODE while in standby mode.
display changes to .
Note
• You cannot back to previous track by pressing r during random play.
• You cannot select one-track repeat during random play.
Repeat play → K
Press PLAY MODE during playback to select repeat play as follows.
: one-track repeat
B
V
: all-track repeat
V
no repeat play (normal play)
Press sSTOP/OFF/CHARGE.
Press ePLAY/PAUSE.
To resume, press it again.
Press r or t.
Keep r or t pressed.
Release the button at the start of desired
passage.
.