Iso Din Radio Provision With Pocket - Metra 99-5027 Instrucciones De Instalación

ISO DIN radio provision with pocket

1. Attach the ISO brackets to the radio housing, and
then secure using the (2) #8 x 3/8" Phillips screws
provided and then snap the correct radio housing
trim piece to the radio housing. (Figure A)
2. Remove the metal DIN sleeve and trim ring from the
aftermarket radio.
3. Slide the radio into the rear of the radio opening
and then secure with the screws supplied with the
radio. (Figure B)
4. Snap the trim plate into the radio housing. (Figure B)
5. Locate the factory wiring harness and antenna
connector in the dash. Metra recommends using
the proper mating adapter from Metra or AXXESS.
Test the radio for proper operation.
6. Reassemble the dash in reverse order of
disassembly.
99-5027
Kit Assembly
(Figure A)
10
(Figure B)