Iso Din Radio Provision With Pocket; Iso Ddin Radio Provision - Metra 99-9011 Manual Del Usuario

ISO DIN radio provision with pocket

1. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
2. Secure the ISO DIN brackets to
the radio with the screws supplied
with the radio. (Figure A)
3. Slide the assembly into the radio
housing until the side clips engage.
(Figure B)
4. Attach the ISO DIN trim plate onto
the completed assembly. (Figure C)
5. Snap the pocket into the radio
housing. (Figure C)
6. Locate the factory wiring harness
and antenna connector in the
dash. Metra recommends using
the proper mating adapter from
Metra or AXXESS. Test the radio for
proper operation.
7. Reassemble the dash in reverse
order of disassembly.
Kit Assembly
(Figure A)
(Figure B)
(Figure C)
®
99-9011

ISO DDIN radio provision

1. Carefully cut and remove the
center divider from the radio
housing. (Figure A)
2. Snap the ISO DDIN brackets to the
inside edge of the radio housing.
(Figure B)
3. Slide the radio into the assembly
and secure using the screws
supplied with the radio. (Figure C)
4. Attach the ISO DDIN trim plate onto
the completed assembly. (Figure C)
5. Locate the factory wiring harness
and antenna connector in the
dash. Metra recommends using
the proper mating adapter from
Metra or AXXESS. Test the radio for
proper operation.
6. Reassemble the dash in reverse
order of disassembly.
7
(Figure A)
(Figure B)
(Figure C)