Iso Din Radio Provision With Pocket - Metra 99-5721 Instrucciones De Instalación

ISO DIN radio provision with pocket

1. Remove the metal "DIN" sleeve
and trim ring from the aftermarket
radio.
2. Mount the ISO Brackets to the
radio with screws supplied with
radio. (Figure A)
3. Snap the pocket into the lower
opening of the radio/housing
climate panel until it clicks in.
(Figure B)
4. Slide the radio into the upper
opening of the radio/climate
housing panel until the side clips
engage. (Figure C)
5. Snap the ISO trim plate into the
radio/climate housing panel.
(Figure C)
Kit Assembly
6. Connect the climate extension harness
to the climate control harness removed
in step 12 of disassembly, and then
into the radio/climate housing panel.
7. Locate the factory wiring harness
and antenna plug in the dash. Metra
recommends using the proper mating
adapters from Metra and/or AXXESS.
8. Reassemble the dash in reverse order
of disassembly, using the radio/climate
housing panel instead.
(Figure A)
®
99-5721
(Figure B)
(Figure C)
5