Accessories And Attachments; Assembly And Adjustments - DeWalt D28490 Manual De Instrucciones

SPINDLE LOCK (FIG. 2)
The spindle lock pin is provided to pre vent
the spindle from rotating when installing or
removing wheels. Operate the spindle lock
pin only when the tool is turned off and
unplugged from the power source. To
engage the lock, depress the spindle lock
button (C) and rotate the spindle until you
are unable to rotate it further.
NOTE: Never depress the spindle lock
button while the grinder is running. Never
turn on the grinder while the spindle lock
button is depressed. Damage to your tool may result.
MOUNT
The grinder is equipped with a mount, enabling easy wheel instal lation
and removal.

Accessories and Attachments

It is important to choose the correct guards, backing pads and
flanges to use with grinder accessories. See the chart on pages
27–29 for information on choosing the correct accessories.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments
or accessories. Before reconnecting the tool, depress and
release the trigger switch to ensure that the tool is off. An
accidental start-up can cause injury.
FIG. 2
C
NOTE: Wheel size must match guard size; i.e., a new 7" (180 mm
wheel may not be used with a 9" (230 mm) guard. The bottom
surface of wheel must be inside the bend of the guard lip.
27
Sanding Flap Disc
mount
Type 27 guard
Type 27 guard
backing flange
hubbed sanding
flap disc
non­hubbed sanding
clamp nut
mount
flap disc