Trix 26000 Serie Manual De Instrucciones página 17

Notes on operation with direct current
G Travel function: Forwards – Stop – Reverse.
G Light change.
G A filtered direct voltage is required for operation.
Operating systems with pulse duration control are
therefore unsuitable.
G Minimum voltage: 7 – 8 Volt =.
Notes on the DCC multi-train system
G Set address ex works: 03.
G Driving operation: Forwards – Stop – Reverse with
load regulation.
G Speed levels: 14 speed levels preset in DCC ope-
ration; 28 or 128 speed levels are detected and
set automatically.
G Function:
– F0/light function: on/off
– F3: Sound effect for a horn
– F4: Minimises the set starting and braking delay
Malfunctions resulting from changes to the factory
G
settings of the locomotive electronics are caused
by the operator and do not give grounds for com-
plaint under our guarantee or warranty obligations.
G The installed locomotive electronics offer a wide
range of adjustment options according to the
NMRA/DCC standard. A series of parameters are
stored to this end in what are known as CVs
(abbreviation for Configuration Variable). Please
refer to the operating instructions for your system
for the procedure for changing these setting
values. This operating system must comply with
NMRA/DCC standards if a perfect programming
function is to be guaranteed. The use of an un-
suitable operating system does not give grounds
for complaint under our guarantee or warranty
obligations.
G We recommend that you always change just one
setting value and see what effect this has.
G Before changing parameters, you must remove
any smoke generators that have been fitted.
G CV 8 is an important CV. Writing the value "8" will
result in the complete component being reset to the
factory settings that applied at the time of delivery!
17